Keeping your Bottle Washer Pro clean and well maintained is essential to ensure proper cleaning and optimal performance. See below our top tips—from descaling and jet maintenance to cleaning components and preparing your machine for storage—helping you keep it running smoothly and efficiently for every use.
Descaling with the Baby Brezza Bottle Washer Pro Descaling Tablets
Mineral buildup within your machine’s internal components can lead to reduced performance or faults over time. Regular descaling using the Bottle Washer Pro Descaling Tablets helps maintain both the internal system and overall machine efficiency.
To descale your machine, please follow the steps below or watch this video tutorial for further help;
- Fill the clean water tank to the FILL line with tap water.
- Dissolve one descaling tablet in a small amount of hot water in a cup.
- Once fully dissolved, pour the solution into the clean water tank with the cold water.
- Run a standard 19-minute wash cycle.
- For heavier buildup, the process may need to be repeated several times to achieve optimal results.
Bottle Washer Pro Descaling Tablets are available to purchase from the Baby Brezza UK website here.
Jet Maintenance
Mineral residue can also buildup inside the jets, this can block water from coming out and stop your bottles from being cleaned fully. This build up can also cause white residue to transfer onto your bottles. Checkout the image below highlighting the buildup in the jets
This is super easy to remove by following the steps below;
- Use a toothpick or small brush to remove the build up from inside the jets,
- Then wash both jets and centre tubes thoroughly in warm soapy water to get rid of any other residue
- Leave to fully air dry before placing back into your machine
Cleaning, descaling and maintaining the machine as per the manual will ensure an optimal performance each time.
Cleaning the Intake Filter
If the intake filter gets clogged, it can cause the machine to stop draining effectively. To ensure your machine is draining as normal after each cycle, keep the intake filter clear & clean by following the steps below when needed;
- Remove the intake filter from the sump
- Hold under running water to dislodge any debris, then wash thoroughly in warm soapy water
- Allow to fully air dry before placing back into the machine
Cleaning for long term storage
Since there is no storing of water internally in this machine, minimal cleaning is required before storing your Bottle Washer Pro.
Hold down the wash mode and sterilize dry button for 7 seconds to activate the discharge pump and get rid of any water into the Waste Water Tank. Cleaning the machine, descaling it and wiping the exterior down with a cloth is also advised. You can find instructions on how to descale your Bottle Washer Pro here.
It’s recommended storing it out of the sun, in a dry dark place to avoid any discolouration over time. When removing the machine from storage, wipe down any parts that were exposed to dust, and run a quick cycle without soap to get the machine ready to be used again.
